Select type, year, make, and model
Reclaim absolute authority over your quad or pit bike with the high-strength ProTaper SE ATV High Handlebar, the industry standard for riders who demand rock-solid feedback . Constructed from premium 5mm thick, proprietary 2000 series T6 aluminum alloy, this Seven-Eights (SE) bar delivers a staggering 70,000 psi ultimate tensile strength to aggressively resist bending, fatigue, and catastrophic roost impacts . By blending a high-rise posture with a cold-forged aluminum crossbar brace, it minimizes hand-numbing vibration while giving you optimal physical leverage over brutal off-road trails .
Part number 025257 features a true 7/8-inch (22.2mm) standard diameter profile from clamp section to bar tip, allowing it to drop directly into your vehicle's factory bar perches without requiring expensive oversized conversion hardware . The **ATV High bend** provides a towering 160mm total height with a relaxed 100mm pullback, making it a verified direct replacement or premium ergonomics upgrade for the following applications :
CRITICAL INSTALLATION & CABLE CLEARANCE WARNING:
The ATV High bend features an expansive 6.3-inch (160mm) total height configuration . When installing this component as an upgraded taller bar to replace standard low-profile factory setups, **always mock up the installation to verify that your stock throttle lines, clutch cables, and front hydraulic brake hoses have enough free slack** . Pull the bars to a full left-to-right steering lock to make sure lines do not yank tight, bind up, or pull the throttle open. If your factory control routing is too short, you must purchase extended-length cables prior to track riding.
| Attribute | Specification |
|---|---|
| Handlebar Series | SE (Seven Eighths) with Crossbar Brace |
| Bend Configuration | ATV High (Bend Designation: 2110D) |
| Clamping Diameter | 7/8 in. (22.2 mm) Standard Diameter |
| Total Base Width (A) | 813 mm (32.0 Inches) |
| Total Face Height (B) | 160 mm (6.3 Inches) |
| Structural Rise (C) | 104 mm (4.1 Inches) |
| Clamping Area Width (D) | 236 mm (9.3 Inches) |
| Sweep / Pullback (E) | 100 mm (3.9 Inches) |
| Control End Area (F) | 199 mm |
| Material Base | 5mm Proprietary 2000 Series T6 Aluminum Alloy |
| Surface Finish | Stress-Relieved, Shot-Peened Jet Black Anodized |
| Total Bare Weight | 1.8 Pounds (820 Grams) without crossbar pad |
| Manufacturer Part Number | 025257 |
US Dollars
